How NMFC Freight Class Is Determined
The four characteristics that set your freight class — density, stowability, handling, and liability — explained in plain language.
Every less-than-truckload (LTL) shipment in North America is priced from a freight class: a number from 50 to 500 published in the National Motor Freight Classification (NMFC). The lower the class, the cheaper the shipment — class 50 freight moves for a fraction of what class 300 costs for the same weight. Most shippers know the number matters; fewer know exactly where it comes from. This guide walks through the four characteristics the NMFC uses to assign a class, and why understanding them is the single fastest way to lower your freight bill.
Class is set by the commodity — usually
The NMFC groups commodities into thousands of item numbers, and each item either carries a fixed class or a density-based one. A fixed-class item always ships at the same class no matter how you pack it — if your commodity is listed as class 70, it ships at 70 whether it's loose, boxed, or palletized. Density-based items are different: the item number lists a range of allowed classes, and your actual shipment's density decides which one applies. You can look up any item number in our NMFC search to see whether it's fixed or density-based before you tender the freight.
1. Density — the biggest lever
Density, measured in pounds per cubic foot (PCF), is how much your freight weighs for the space it occupies. Carriers care because trailer space — not weight — is what they sell. A pallet of steel fittings and a pallet of pool floats might take identical space, but the steel pallet pays far less per pound because it uses that space more profitably.
Density is calculated by dividing total weight (including all packaging and pallets) by total cubic feet. The standard scale runs from class 50 for freight at 50 PCF or denser, up to class 500 for freight under 1 PCF. Every step down the scale is a step up in rate, which is why careless measurement is so expensive: an inch of extra bulge on each side of a carton can push a shipment from one class breakpoint to the next.
2. Stowability
Stowability asks how easily your freight loads alongside other freight. Odd shapes, excessive length, overhang, or hazardous characteristics make a shipment harder to combine with others in a trailer. Items that are nestable or stackable stow well; items that are round, crated at strange angles, or restricted from loading next to food products stow poorly. Poor stowability can bump an item's class above what its density alone would suggest.
3. Handling
Some freight needs more than a standard forklift and two hands. Odd shapes, fragile contents, or items that require special equipment (like a clamp truck) increase the carrier's cost to move it. The easier your shipment is to handle with normal LTL equipment, the friendlier its class.
4. Liability
Liability covers the carrier's exposure if the freight is damaged, stolen, or causes damage to other freight. High-value, perishable, hazardous, or damage-prone commodities carry higher liability, and the NMFC accounts for that with a higher class. Packaging matters here too: the same product, properly crated, can classify better than the same product shipped loose.
Why this matters on every quote Carriers quote LTL from the class and weight on the bill of lading — then verify it. If the density or class you declared doesn't match what they measure, they re-class the shipment and back-bill the difference, often with an added inspection fee. Accurate classification isn't just compliance; it's budget protection.
The practical takeaway
Before shipping, find your item number in the NMFC, note whether its class is fixed or density-based, and if it's density-based, measure and weigh carefully — packaging included — so the class on your BOL matches what the carrier will find. Our free density calculator does the math for you and recommends the right class from your item's breakpoints.
Find your carrier’s identifier with the free SCAC code lookup.